河北快3杀号软件

Welcome to Xi'an Bohao Electric Furnace Co., Ltd!
Your present position:Home > News
News

Contact us

Hotline 029-62588993

Company news

Xi 'an boda independent research and development o

Release date:(2018-4-1)   Number of clicks:61

Self-developed 350KW/3.0KHZ wire heating system, including power supply, inductor furnace body, inert gas tube,

guide device and cable accessories. The equipment for export projects, by the customer to provide front and rear

end tensioning mechanism, the composition of aluminum clad steel production line。 The induction coil is provided

with an insulating layer outside to reduce heat loss, and an insulating tube (inert gas protection tube) with special

materials inside to isolate the wire from the coil and prevent it from being worn and broken。 On both ends of the

induction coil and combining site support to turn the Φ 8 mm double mouthwash tungsten steel mold. After years

of appearance modification, our goal is to make industrial equipment into home appliance products.



The main parameters of the equipment are as follows:

1. The heated material diameter: 2.8 ㎜ Φ ~ 7.0 ㎜ Φ.

2. Heating method: online continuous heating.

3. High wire speed comparison: 180m/min.

4。 The heating temperature: 380 ℃ ~ 420 ℃, temperature range + / - 5 ℃。


5. The heating temperature requirements according to the wire diameter and linear velocity in the range of 380 ℃ ~ 420 ℃ even adjustable, and can be overloaded. Provide heating power control interface can be centralized control, and ensure the Φ 6.5 ㎜ wire online speed of 150 m/min under the conditions of heating temperature can reach 420 ℃. Equipped with heating power "manual" and "automatic" switch, easy to debug. Failure signal and passive contacts are provided if normal overload start or fail-stop is not available.

6. Medium frequency power supply control requirements: manual control of heating and linkage with the unit control of heating. Linkage reserved interface is adopted to connect with the controller (PLC). The induction heater of intermediate frequency power supply can be started independently or linked with the host machine.

7. All cooling water pipes of inductor furnace body are made of stainless steel.

8. The height of the equipment center is 1333mm.

9. The steel wire inlet is equipped with incoming regulating wheel, and the outlet is equipped with connecting flange for installing external inert gas protection pipe.

10. Equipment direction: forward (equipment oriented from left to right), side-mounted.

上一篇:Extensive basic knowledge - if furnace induction h 下一篇:6600kW intermediate frequency induction steel ball
Copyright:Xi 'an boda induction technology co. LTD Record number: Technical support:
安徽快3软件下载 天津11选5走势图 海南4+1 博九 河北快3APP下载 海南4+1 河北11选5 天津快乐十分 博九 贵州快3杀号软件